REDA Cycle Stick Instructions
Harley Davidson
Hard Bags
The REDA Cycle Stick mounts to existing screws that hold the teather strap for the hard bags. Remove screws ONE AT A TIME and re-attach with clips as shown.
Harley Davidson
Tour Pack
The REDA Cycle Stick mounts to existing screws that hold the luggage rack. Remove the existing screws ONE AT A TIME and re-attach with the clips as shown. Make sure to use the LARGE washers as shown
Harley Davidson
Road King & Other bags
The REDA Cycle Stick comes with 2 small screws to mount in the H-D Road King and other models. These screws allow you to mount the clips anywhere you feel will optimize the light from the stick. On the Road King we mounted it on the back side of the bag at the top and approximatelly in the center. Mount the clips in between the LED as to not obstruct them.
Supplied magnetic disk
Magnet on end of REDA Cycle Stick
The REDA Cycle Stick serves as an EMERGENCY FLARE. Attach the magnetic end of the cycle stick to the magnetic base and place behind your bike about 15 feet.
Your roadside visability just increased 1 MILE ! ! !
Battery Replacement
Unscrew end cap (opposite of button) and slide battery cartridge out. Replace 3 triple A batteries
End Cap
Slide Battery Cartridge out
On/Off Button
When putting the battery cartridge back inside the aluminum tube make sure you line up the keyway (see below) and the LED modules in the tubes 4 opening or the lightstick will not properly go back together. Tighten the end cap as tight as you can by hand. TIP - We use a rubber pad like you would use to open jars to tighten it back on.
Keyway